Code Search

Please fill the "Code Box" to find engine fault code.

Car Models :

Please select your car.

How To Clear Check Engine Lights ?

Ways to clear check engine light on car panel.

Check Engine Light Dictionary

Ways to clear check engine light on car panel.

U260E Engine Trouble Code

Meaning of U260E engine trouble code is a kind of network trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

U260E Fault Symptoms :

Check engine light comes on
Engine stalling or misfiring
Engine performance issues
Car not starting

If one of these reasons for U260E code is occuring now you should check U260E repair processes.
Now don't ask yourself; What should you do with U260E code ?
The solution is here :

U260E Possible Solution:

Disconnected, dirty or fouled spark plugs are common causes for engines that won't start. Spark plugs typically need to be replaced every season or 25 hours of use. You should also check that the spark plug gap is set properly. If your spark plugs look good, problems with your ignition system can also preventing a spark. These can range from a faulty spark plug lead, shorted kill switch or flywheel key damage.

U260E Code Meaning :

U	2	6	0	e
OBD-II Diagnostic Network (U) Trouble Code For Engine	Fuel And Air Metering (Injector Circuit Malfunctions Only)	Fuel Temperature Sensor B Circuit Range/Performance	Cold Start Injector 1 Malfunction

The poor running symptoms are consistent with a MAP sensor malfunction. In addition, in some cases, a bad MAP sensor will not throw a code. Again, the ELD code likely represents a separate wiring issue.

U260E OBD-II Diagnostic Network (U) Trouble Code Description

U260E engine trouble code is about .

Main reason For U260E Code

The reason of U260E OBD-II Engine Trouble Code is Fuel Temperature Sensor B Circuit Range/Performance.

U260E the main thing to check is to verify the operation of the VCT solenoid. You're looking for a sticking or stuck VCt solenoid valve caused by contamination. Refer to vehicle specific repair manual to perform component tests for the VCT unit.

	Example: 0140